DictionaryForumContacts

 adelaida

link 10.07.2014 7:11 
Subject: for grounds. gen.
Доброго дня.

Прошу помочь уточнить окончание предложения из процедуры проверки электрооборудования
Check control wiring with volt-ohm meter for grounds.

"for grounds."

Спасибо большое.

 trtrtr

link 10.07.2014 7:13 
Привет! Речь не может идти о заземлении?

 gni153

link 10.07.2014 7:21 
она идет

 trtrtr

link 10.07.2014 7:22 
Похоже.

 Lonely Knight

link 10.07.2014 7:35 
замыкание на землю, наверно

 Lonely Knight

link 10.07.2014 7:37 
"Check for Grounds.
With the power off, check for grounds by measuring the resistance between each terminal and the grounding bolt located below terminal 9"

"(3) Check for grounds between wiring harness connector pins A, B, C, E, F and J and pin D(ground). (Refer to schematic diagram, WP 0015 00-7.) There should be an open circuitbetween the connector pins. If there is continuity between any connector pin asspecified, that circuit is grounded and the wiring harness must be repaired or replaced"

 gni153

link 10.07.2014 7:39 
ground wire-провод заземления
live wire=провод под напряжением

 

You need to be logged in to post in the forum

Get short URL | Photo