weld/power speed weld.

[Kuno]

At least once a month, run engine at _weld/power speed_ and press Test button to verify GFCI is working properly.

Use switch to start engine, select speed, and stop engine. In Run/Idle position, engine runs at idle speed at no load, and _weld/power speed_
under load. In Run position, engine runs at weld/power speed.

Weld/Power Speed Adjustment
Move Engine Control switch to Run position.
4 Jam Nut
5 Lock Nut
6 Weld/Power Speed
Adjustment Screw
Loosen jam nut and lock nut. Turn adjustment screw until engine runs
at _weld/power speed_. Tighten jam nut, and then tighten lock nut.