|
link 18.12.2007 18:56 |
|
Subject: to clip on the high end to clip on the high end - ?The Vff input should always be set up so that Vff is equal to 1.414 volts at the minimum input voltage. This may cause Vff to clip on the high end of the input voltage range if there is an extremely wide AC line voltage input range. However, it is preferable to have Vff clip at the high end rather than to have the multiplier output clip on the low end of the range. |
| ограничение на уровне верхней границы диапазона |
| You need to be logged in to post in the forum |