|
Subject: sail gate gen. Документ по smartgate3.2 Connecting a Master Gate
1. Remove the Gate from the box, and place in the desired location.
2. Remove the two base mouldings via four M4 screws on the side.
3. Once the screws are removed, the lower half of the moulding can swing out and the moulding eased upwards and off.
4. Floor fixing is via four fixing holes in the base plate. Use the same floor anchor bolts as used on the origional ***sail gate. If Hilti glued bolts are being used then it is advised, due to clearances, that on the (master Gate only), the bolt below the reader box does not protrude above the ground any more than 17mm. Otherwise use standard floor anchors. Буду благодарна за любые идеи.
|