|
Subject: straight-through Речь о передней сдвоенной управляемой оси грузовика.Adjustment for Twin Steering Primary and Main Shaft Straight-through Is Shown in Fig. 7-12a Ниже привожу два предложения с интересующим термином. (1)Put the primary shaft wheel at the straight-through position using the wheel straight through alignment gauge, and rotate the steering gear input shaft to the upper end surface reticule, facing right ahead (at this moment the steering gear is in the middle position),and then adjust the length of the steering drag link to enable both ends to connect with the steering rocker and steering knuckle arm respectively. И: If it is found that the truck has a defect in the main shaft tire during operation, then it is required to check if the tire shows any tear and wear while checking the truck straight-through, and if there is an obvious lateral slip mark, it shows the tire position is incorrect, and at this moment, it needs to identify the direction and size of the wheel deflection |
| You need to be logged in to post in the forum |