Terms for subject Drilling containing 孔

Chinese	English
一次起下作业的射孔与充填完井系统	single-trip, perforation packing completion system
不连通孔隙	non-conductive pore
丝堵孔	screw port
井壁中孔隙度测井	sidewall neutron porosity log
人孔	scuttle
人孔	approach hole
充气孔	air-filled hole
冲孔机	punch
泵的冷缸孔	pump bore
冷缸孔	cylinder bore
分散气孔	scattered porosity
加油孔	lubrication port
泥浆泵十字头检查孔盖	crosshead inspection plate
单个气孔	individual pore
原始孔隙度	in situ porosity
双卡瓦大孔单管封隔器	double-grip large bore single string packer
另钻新孔	side track
呼吸孔	stoma
喉孔	throat pore
地层孔隙压力梯度	formation pore pressure gradient
埋头螺孔	countersunk
塞孔	tip jack
塞孔	taphole
塞孔	rabbet
塞孔接触点	female contact
声波测井孔隙度	sonic porosity
声波测井孔隙度	acoustic porosity
多孔岩层	porous rock
多孔岩层	porous formation
多孔的	honeycombed
多孔的	coral
多孔的	cavernous
多支井眼大孔系统	multilateral widebore system
大直径套管射孔器	big casing gun
射孔孔数/英尺	shots per foot
孔板流量	orifice discharge
孔板流量系数	orifice flow constant
孔板流量系数	orifice constant
孔板流量计	orifice plate
孔板流量计	orifice flow meter
孔板流量计试油	orifice well tester
孔板节流器	orifice choke
孔洞	cavity void
孔道	gutter
孔隙	interstice
地层孔隙压力预报	pore pressure prediction
地层孔隙压力预测	pore pressure prediction
孔隙度传感器	porosity sensor (MWD 配置)
孔隙性地层	porous formation
孔隙的	honeycombed
孔隙连通性	pore communication
孔隙连通通道	pore passage
孔隙连通通道口	pore throat
射孔	shoot
射孔	shot
射孔	lay an egg
射孔作业	perforation job
射孔作业	perforating practice
射孔器	gun perforator
射孔器	shot tool
射孔器	gun
射孔失败	flush perforation
射孔孔眼	bullet hole
射孔完井法	perforation completion
射孔完成的井	perforated well
射孔完成的井	perforated hole
射孔层段	perforated zone
子弹射孔枪	firing gun
射孔枪	bulletgun
射孔枪	perforation gun
射孔枪	shot gun
射孔枪	perforator
子弹射孔枪	bullet gun
射孔深度	perforation depth
射孔的	perforated
射孔费用	perforation charge
射孔费用	perforating charge
射流孔	jet hole
小孔	pore
小孔	pin hole
小直径射孔器	small diameter perforating gun
尾管射孔完井	liner perforation completion
岩心孔隙率	core porosity
岩石孔隙	rock pore
岩石孔隙率	rock porosity
已射孔套管	perforated casing
已射孔尾管	perforated liner
已射孔衬管	perforated liner
带孔偏重钻铤外表一侧有一列圆坑	indented drill collar
带堵头的排泄孔	plug drain
带销孔的螺栓	pin bolt
开孔	open up a hole
开孔	open up
总孔隙率	gross porosity
手探孔	hand hole
打孔	slotting
扩孔	bore
扩孔焊接	counterbore weld
排放孔	drain hole
排沙孔	sand hole
排泄孔	escape orifice
排泄孔	escape hole
排液孔	vent hole
斜孔	inclined hole
方孔	square opening
方孔筛网	square-mesh screen
无孔缝套管	blank casing
曲轴箱强制通气孔	positive crankcase vents
最大转盘开孔直径	max. table opening
有效孔隙体积	net pore volume
有效孔隙度	practical porosity
有效孔隙空间	net pore space
检查孔	peep hole
检查孔丝堵	opening check plug
检查孔盖板	inspection plate
正常孔隙压力	normal pore pressure
气孔	gas pocket
气孔	air hole
水泥充填井壁孔隙与裂隙	walling up
汽缸孔	cylinder port
汽缸孔	cylinder bore
油底脚排泄孔	tank drain
油罐量油孔	tank dip hole
油罐量油孔	tank dip hatch
泄油孔	oil drain hole
泄油孔	oil drain
流量孔板	diaphragm
清井并射孔	clean out & shoot
清砂孔	cleanout opening
沉砂罐清砂孔	clean-out opening
清砂孔盖板	clean-out plate
清砂孔盖板	clean-out cover
渗透孔隙堵塞	permeability plugging
牙轮滑套孔	bushing hole
滑套上的孔	sliding sleeve port
滑套式侧孔循环装置	sliding side door circulating device
爆炸扩孔	pot
穿孔	hole
穿孔器	pecker
筛孔堵塞	screen plug
筛孔大小	sieve opening size
筛孔尺寸	screen size
筛孔目数	screen number
管壁未射穿的射孔	flush perforation
粗孔筛	riddle
细孔筛网	fine screen
缸套内孔	liner bore
泥浆泵缸套密封圈泄漏观察孔	tell-tale hole
罐顶取样孔	hatch
网格构造孔隙度	fenestral porosity
聚能射孔	shaped charge shooting
聚能射孔器	jet gun
胶结作用所致的孔隙度损失	cementational porosity lose
节流孔板	restricted orifice
螺丝孔	screw port
法兰螺栓孔中心圆	bolt circle
蠕虫状气孔	worm hole
补射孔	reshooting
补射孔	perforation adding
观察孔	observer
观察孔	inspection door
视孔	eyelet
转盘方孔	table opening
进入孔	approach hole
进气孔	admission opening
连通孔隙	open pore
通气孔	gas vent
通气孔	air breather
通风孔	fresh air inlet
量孔	hatch
油罐顶部量油孔	gauge hatch
量油孔	gage hatch
金刚石钻具钻孔	diamond-drill-hole
针孔状气孔	pin hole
钻孔	hole
钻孔	piercing
钻孔	bored
钻孔多点应变仪	multiple position borehole extensometer
钻孔灌注	cast-in-drilled-hole
钻孔设备	boring apparatus
钻孔钻进规程调整	handling a well
钻井参数求得的孔隙度曲线	drilling porosity log
钻井船壳体上的桩腿通孔	spud well
锁孔	pin hole
锥口孔	countersunk
旋流分离器锥顶排泄孔	apex discharge opening
镗孔	counterbore
阀缸的上排水孔	valve pot opening
随钻孔隙率测井	MWD porosity log