Subject: Fit cable gland into the electrical conduit gen. Pressure switches with H100 enclosures• Remove the cover (four screws) • Fit the appropriate cable gland into the electrical conduit (4). See specifications for the right size and type of the thread. • Connect the electrical cable to the terminal block (3) according to the code. (See section electrical connection). The wire core may not exceed 2.5 mm2. • Check that the cable is properly enclosed and that it is not under tension. The "IP" weatherproof rating depends on these measures being taken. • If necessary, adjust the set point using the adjusting nut (2). (See section set point adjustment). • Replace the cover, including the gasket, making sure the screws are tight.
|