Subject: EOL termination DIP switches gen. 5.4 Connecting the flowmeter Note End Of Line (EOL) termination The flowmeter EOL termination DIP switch is default set to EOL active. To change termination setting see Setting the EOL termination DIP switches (Page 44). 5.4.3 Setting the EOL termination DIP switches It is important to terminate the Modbus RS 485 line correctly at the start and end of the bus segment since impedance mismatch results in reflections on the line which can cause faulty communication transmission. If the device is at the end of the bus segment, it is recommended to terminate the device as shown in System configurations (Page 45). The table below shows the relation between the DIP switch settings and the permissible communication interface set-ups. Default configuration is EOL active. EOL termination DIP switches - DIP-переключатели с терминацией конца строки (EOL) ?????????
|