Subject: Система для этикетирования - Pre-dispense Length automat. Термин встречается в следующем контексте:To achieve the most appropriate labeling effect, the label should be pre-dispensed to some extent such that the label is closer to the substrate than the dispensing edge but without touching the substrate. The pre-dispense length cannot be too short, otherwise it may cause higher error in labeling or missing label. If the pre-dispense length is too long, wrinkling may occur. To adjust the pre-dispense length, adjust the label offset parameter. The relationship between these is shown below. Ideally, the pre-dispense length is about 0.5~2mm.
Спасибо
|