 |
|
Subject: to the configured number .... while the other will have a board less than those configured помогите плиз перевести:to the configured number .... while the other will have a board less than those configured An addressed I/O board is not in the ring. This malfunction may be caused by an incorrect ring configuration or a broken or badly configured node. For example, if the address of two nodes with respectively 2 and 3 boards is inverted, one node will have an extra board to the configured number (situation ignored by the CNC) while the other will have a board less than those configured (situation that generates the fault). The I/O link is inhibited and all the outputs are set to low level. Check the ring configuration (IOREDIR editor) or the configuration of the nodes and their addresses. |
| You need to be logged in to post in the forum |