Asunto: Mold No Это инструкция к инжекторно-литьевой машине по литью изделий из пластических масс.У меня есть догадка, что Mold No- это количество движений, которое сделала пресс-форма. Ведь это не может быть количество пресс-форм, так как она одна в машине. |
|
enlace 21.08.2008 8:27 |
может NO normally open нормально разомкнутый |
С таким контекстом только гадать - Форма Номер |
|
enlace 21.08.2008 8:34 |
Alap дайте контекст! |
А у вас есть инструкция к этой машине на русском языке? |
2、MOLD No. page Pressing key will display “Mold No.” page as follows: (1) Curr.No.: input the mold No., any modification of data will be saved in this mold No. |
Machine state: Mold No.: The mold No. of current data. Opentotal: Display the times of mold open. When the power is off, the computer will store the data into the mold data. If the mold needs to replace or recount,‘Opentotal’ needs to reset. (The return-to-zero way of ‘Opentotal’ refers to selection 4 of chapter 4) Curr temp: Display the practical temperature of each zone of the barrel. Set: Display the setting temperature of each zone of the barrel. Act: Display the operation the machine is running. Warning: Display the abnormal state of the machine.(if the machine works normally, it won’t display) Cycle: Display the time of producing a product. Set: If there is the time value or count value in the operation flow, for example, decompress times or ejector times, the machine will display the setting value. 9. Oper: If there is the time values to be set in the action, the operation time will start from 0, and increase by the speed of 0.1s ,until it reaches the setting value, the machine do the next action. If the setting value is the times, the item will show the times of action having been runnd and till to the setting value. 10. Press: Display the setting pressure of current action. 11.Speed: Display the setting speed of current action. 12.Mold: It is the current position of the movable board. (The encoder is shown in pulse number and the indicated value of electronic ruler is the actual position) 13.Screw: 14.Eje.: 15.Rotation: 16.BackP |
|
enlace 21.08.2008 8:44 |
Нет наши наладчики спрвляются без неё, у вас Netstal nkn какая другая машина? |
Машина китайская какая-то Injection molding machine N1500/ Вот застопорилась на переводе этого MOLD No. Так и не пойму то ли это Пресс-форма № , то ли это количество движений , которые она делает....прям теряюсь в догадках. На дисплее можно как-то менять этот MOLD No |
|
enlace 21.08.2008 9:14 |
я сейчас консультировался с нашими у нас этой опции нет, но они сказали что это наверняка номер, может вы знаете что пресс-форму можно менать в зависимости от размера изделия.Наши наладчики перевешиют их в течении 2 часов. |
Se necesita iniciar una sesión para participar en el foro |