Subject: Flow-Through Sample Cells, Diffusion Baffle, Septum Помогите, пожалуйста, перевести названия частй прибора для определения удельной площади поверхности катализатора (те, которые выделены жирным шрифтом).Контекст: Apparatus 6.1.1 Differential Flow Controller from the gas inlet valve to a flow control valve to eliminate fluctuations in the gas flow. 6.1.2 Two Thermal Conductivity Detectors—A reference detector (A) to sense the nitrogen-helium gas mixture and a second detector (B) to sense changes in the gas mixture after flowing through the sample cell. The two detectors are initially balanced to allow the detection of changes in the nitrogen concentration. 6.1.3 Flow-Through Sample Cells, of various volumes and shapes depending on the application. 6.1.4 Two Equilibration Tubes selected by a selector valve, between the sample cell and detector (B). The small volume tube has a volume of approximately 20 cm3 and the large volume tube has a 100 cm3 capacity to allow for temperature and pressure equilibration of a wide range of volumes of gases. 6.1.5 Flow Meter, to monitor the flow rate of the nitrogenhelium mixture maintained at approximately 20 cm3/min. 6.1.6 Diffusion Baffle, to prevent air from diffusing back into the system during cooling of the sample. 6.1.7 Bridge Balance Meter, to display balance or imbalance between detectors A and B. 6.1.8 Digital Integrator, to measure the imbalance between detectors A and B and display the surface area of the sample. 6.1.9 Septum or Fixed Loop, for injection of calibration gas. 6.1.10 Degassing Station, for removal of adsorbed vapors from the sample. Большое спасибо заранее
|